Ensure the natural lashes are cleaned thoroughly.Prepare the lashes by curling using a eyelash curler.Wipe any excess Bonder off the applicator and apply a light amount of the Bonder to the natural lashes, focusing on the root of the natural lash. One coat is enough. You can always apply a little more if required.Using our Applicator gently lift the cluster off the strip just above the invisible band. Ensure you pick up the cluster in whole. Gently apply to the underneath of your natural lashes. Avoid applying the lash too close to your waterline. Apply the lashes across your eye to create a beautiful look. We recommend using anything from 3 lash clusters for a natural result or up to 5 lash clusters for a fuller look.Apply one layer of Sealant to the root of the lashes to seal the Bonder and set the cluster lashes in place.RemovalBegin by applying the Miss Wispy Remover (not included) onto the base of the Cluster lashes. Allow 30-35 seconds for the lash Bond & Seal to dissolve. Always use Miss Wispy Remover Only. Using a different product may damage your eyes and lashes. Gently brush the cluster lashes with the lash remover, moving from the bottom to the top, until the cluster lashes naturally release. Carefully use a soft cotton pad to eliminate lash clusters and any residual makeup, followed by a thorough eye rinse. Repeat this process as needed until all residue is completely removed.
Patch Test
Our Miss Wispy Bond, Sealant and Remover are all hypoallergenic. However, we recommend carrying out a patch test 24 hours before using. Do not continue use if you experience any reactions, discomfort or sensitivity.
Warning
Miss Wispy Remover must always be used to remove Miss Wispy Bond and Sealant to protect your eyes and prevent any damage to the lashes and keep natural lashes healthy and safe.
